Installation guide and operating instructions for the dust collector
Or a dust collector quick start guide.
It is important to install the filter correctly
The filter is installed correctly if the dust collector housing is tightly screwed on, and the inside of the filter is visible through the upper flower hole (see image). The filter fits snuggly in its compartment. This is necessary to ensure a hermetic seal.
If you find it difficult to feel the suction with your hand, you can check the operation of the dust collector using a sheet of paper or directly during a procedure.
Correct Position
In order to ensure that the dust collector housing does not fall off, you need to position it along the same axis as the pantograph (metallic mount).
When installed this way, the dust collector will be seated evenly and stably.
To prevent deformation of the pantograph rod, position the dust collector correctly, as indicated in the diagram.
Safety Equipment
WARNING: Make sure to keep hair, clothing, and small objects away from the openings in the grille and the motor blades. When the dust collector is turned on, you will hear a characteristic sound similar to an airplane jet engine starting up. Do not be alarmed: This is just a normal feature of this type of motor.
Cleaning and care
To ensure that the dust collector works flawlessly, the filter must be cleaned and replaced regularly. We recommend cleaning the filter 3−4 times per month (every 20−30 procedures).
Remember: The filter should not come in contact with water or another liquid! When cleaning the dust collector and replacing the filter, be sure to wear protective equipment (mask and gloves).
How frequently to change the filter
We recommend replacing the filter with a new one if there is a noticeable reduction in the suction power. The filter has an approximate service life of 2 to 6 months (provided that the filter is emptied and cleaned at regular intervals) depending on how much the device is used.
When replacing the cleaning the filter DO NOT throw away the filter cap for attaching the filter!
We ask specialist pedicurists who provide podiatry treatments in particular to evaluate the risks of filter cleaning. If it is likely that the dust may contain opportunistic pathogens, you should not clean filter and instead change it every 1−2 months. Remember: your health is more important than saving money on replaceable filters.
Manicures and pedicures without the dust
Many airborne materials are produced as you work that need to be removed, including fine flying dust (suspended particles that can damage the respiratory tract) and sawdust (large particles that fall down onto the table under their own weight). Therefore, it is important to direct the flow towards the dust collector.
For your convenience, when removing the cover,position the dust collector at an angle to the side opposite of your working hand.The dust collector should be positioned similarly in the pedicure work area.
Sawdust that clings to your glove due to static electricity can be easily removed by running the palm of your hand over the suction surface.
Useful lifehacks
MANICURIST SITTING POSITION When working with a client at a manicure table, use a palm rest. It will help you position the client’s hands higher, which will allow you to align your posture and relieve tension in your back. When you are concentrating on a procedure, do not point your hands at the table, and do not hunch over. Do not forget to practice some stretches and other exercises between client sessions.
REMOVING MATERIAL When removing material, we recommend setting the cutter speed to 25,000−30,000 revolutions, which helps to slow down the particles so that they can form a stream, which you can then direct towards the dust collector.
Sawdust that clings to your glove due to static electricity can be easily removed by running the palm of your hand over the suction surface.
Blog posts
-
How to Avoid Allergies While Working with Gel M...
How to Avoid Allergies While Working with Gel Manicures and Pedicures: A Comprehensive GuideStarting a gel nail business is an exciting venture, but it comes with responsibilities—one of which is...
How to Avoid Allergies While Working with Gel M...
How to Avoid Allergies While Working with Gel Manicures and Pedicures: A Comprehensive GuideStarting a gel nail business is an exciting venture, but it comes with responsibilities—one of which is...
-
How to Start a Gel Nail Business: A Comprehensi...
How to Start a Gel Nail BusinessStarting a gel nail business can be a rewarding journey, blending creativity with entrepreneurship. This comprehensive guide will walk you through every essential step,...
How to Start a Gel Nail Business: A Comprehensi...
How to Start a Gel Nail BusinessStarting a gel nail business can be a rewarding journey, blending creativity with entrepreneurship. This comprehensive guide will walk you through every essential step,...
